What does the service cover?
From design to ground
Setting out support centres, legs, crossarms and conductor directions from the approved design.
Measurements and sections
Using field measurements for required leg sections and final-condition drawings.
Drawings, calculations and deliverables
Support centre setting-out
Surveying and marking the designed support centres on the ground.
Leg and foundation marks
Setting out support legs and foundation dimensions on site.
Crossarm angles
Marking the designed crossarm angles in the field.
Conductor directions
Indicating conductor directions during setting-out.
Leg section calculations
Calculating leg sections from field measurements where required.
Final-condition drawings
Preparing final-condition drawings from field measurements and leg-section calculations.
Technical support from data to implementation
Review the bases
Review the route, line characteristics and available design data.
Fieldwork
Carry out the measurements and marking defined by the service scope.
Drawings and calculations
Transfer field data into the relevant plans, profiles, sections and calculations.